Note: Using a knife or box cutter is not recommended when cutting the KoolerCap.

​

1.  Measure the interior length and width dimensions of your cooler. Write down the measurements.

 

2.  Add 1/4 inch to both the length and width measurements and write them down. This will make the KoolerCap       slightly larger than the inside dimensions of your cooler walls.

 

3.  Place the KoolerCap on a flat, stable, surface.  From one end of your KoolerCap mark your LENGTH dimension       (including the additional 1/4 inch) by placing a dot. Move down this same end 4 to 6 inches and mark your             LENGTH dimension again by placing a dot.

 

4.  Using a straight edge, draw a line across these LENGTH dimension dots from one edge to the opposite edge.

 

5.  Repeat this process with your WIDTH dimensions on the other 2 edges. You should now have a rectangle               drawn on the KoolerCap.

 

Remember; MEASURE TWICE, CUT ONCE.

 

6.  Using a large pair of scissors cut the KoolerCap along the rectangular LENGTH and WIDTH lines.

 

7.  Using scissors, conservatively round, if necessary, the corners of your KoolerCap to closely match the corners       of your cooler. Don't worry if they are a not perfect, the KoolerCap will compress and fill in the corners.

 

CONGRATULATIONS! Your KoolerCap is now ready to provide you with many years of ice saving service.